#Help Cpmmand For Netstat On How To Display All

Other commands are described elsewhere in this publication:This table includes all IP addresses the their associated MAC addresses At the CMD prompt type route print or netstat -r to get the current routing.Where, IP address 192.168.43.160 MAC address 00-aa-00-62-c6-09 This command is used to show the help at the command prompt. For example, you can use an -a switch to display the cached name table for a. (nbt stands for NetBIOS over TCP/IP.) You can use any of the switches listed in Table 6-1 to specify what nbtstat output you want to display. Nbtstat is a Windows-only command that can help solve problems with NetBIOS name resolution. It means that fastpath uses interface caching but not mac caching (this will allow.Using the nbtstat Command.

Should contain executable and service information that could help determine. Of netstat -ano and tasklist commands for windows or lsof -i for Mac/Linux for. General commands are described in the ' General Switch Commands' chapterNetstat (network statistics) is a command line tool that displays network connections. When the interface comes up within the delay time, the ARP entries are restored, and packet loss with ECMP (Equal Cost.

Help Cpmmand For Netstat On How To Display All

Command TypeThe following example shows how to display all aliases:Use the show arp command to display the Address Resolution Protocol (ARP) table. If name is not specified, all defined aliases are displayed.This command has no default setting. Show alias Syntax Description name(Optional) Name of the alias to be displayed. show commands are described in the ' ATM show Commands' chapter show aliasUse the show alias command to display a listing of defined command aliases. General commands are described in the ' General ATM Commands' chapter set commands are described in the ' Switch set Commands' chapter

DefaultThe following example shows how to display bridge information:Table 6-1 describes the fields in the show bridge output.Table 6-1: show bridge Command Output Fields FieldIndicates whether APaRT 1 is enabled or disabled.Indicates whether FDDICHECK is enabled or disabled.Indicates whether IP fragmentation is enabled or disabled.Shows the default method for translating IPX 2 packets across various media.APaRT=automated packet recognition/translationUse the show cam command to display the content-addressable memory (CAM) table. Show bridge Syntax DescriptionThis command has no arguments or keywords. Related CommandsUse the show bridge command to display bridge information. The remaining lines of the display show mappings of IP addresses (or IP aliases) to Media Access Control (MAC) addresses. This value is set using the set arp agingtime command.

Show cdp neighbors ] Show cdp port ] Syntax Description neighborsKeyword used to show CDP information for all Cisco products connected to the switch.(Optional) Number of the module for which CDP information is displayed. Show cam agingtime Syntax DescriptionThe following example shows how to display CAM aging time information:Use the show cdp command to display Cisco Discovery Protocol (CDP) information. If a VLAN is not specified, all VLANs are displayed.The following example shows how to display dynamic CAM entries for VLAN 1:VLAN Destination MAC Destination Ports or VCsUse the show cam agingtime command to display CAM aging time information for all configured VLANs.

Show config Syntax DescriptionThis command has no default setting. Show cgmp statistics Syntax Description vlan_id(Optional) VLAN number for which to display CGMP statistics.The following example shows how to display CGMP statistics for VLAN 2: Console> show cgmp statistics 8CGMP enabled CGMP statistics for vlan 1: valid rx pkts received 48 invalid rx pkts received 0 valid cgmp joins received 23 valid cgmp leaves received 25 valid igmp leaves received 25 valid igmp queries received 22 igmp gs queries transmitted 25 igmp leaves transmitted 25 failures to add GDA to EARL 0 topology notifications received 0 152> (enable) Related CommandsUse the show config privileged command to display the current system configuration.

Help Cpmmand For Netstat On Mac